Make sure the installation area is clean and dry. Clean the surface with a solvent such as PREP-SOL, lacquer thinner, brake cleaner, 409 or Fantastic. The surface must be free of wax, dirt, dust, rain-x, etc. After cleaning with solvent, go over the surface with regular glass cleaner and wipe it dry. The surface should be between 60 and 80 degrees if possible. Peel 1" of the backing down from the decal at the top. Position the decal where you want it. Carefully stick the exposed sticky portion of the decal to the surface. Using a credit card or plastic squeegee held at a 45 degree angle to the sticker, squeegee down the decal while pulling the remaining backing off. Once the entire sticky side of the decal is applied to the vehicle, go over the decal with the squeegee with increasingly harder strokes. Then begin peeling the transfer tape covering the decal. That's it!

If you have questions or comments, please send them to serv@NoMuffinTop.com